Help Classing 2010 WRX

[2010WRXLimited]

I would appreciate any help in classing my car for the upcoming autocross on the 10th. Here's my complete mod list:

Engine:
Torqued Performance stage 3 tune
Tatrrix 2.0 Opensource
AEM Meth Injection System
AEM Meth filter
FMS Front Mount Intercooler
Gimmick Throttle Body Hose
Grimmspeed 3 Port EBCS
AEM cold air intake
Invidia downpipe
Invidia Q300 exhaust
NGK Iridiums 1 step colder plugs
DeatschWerks DW65c 265Lph fuel pump
Prosport Sandwich Adapter for oil pressure gauge
Maddad oil sender relocation kit

Handling:
Whiteline rear sway bar 22mm adjustable
BC Racing BR coilovers with camber plates - 8k front, 8k rear
ATE Super Blue DOT4 brake fluid
DBA4000 slotted front rotors
Hawk HP+ Front brake pads
Hawk HPS Rear brake pads
Goodridge stainless brake lines front and rear
AVO subframe bushings

Exterior:
Crawford Performance carbon fiber wing
Gold Rota G-Force 18 x 8.5 +48 with 255 40 r18 Hankook Ventus V12 Evo tires

Interior:
AEM UEGO AFR gauge
AEM boost gauge
SMY integrated Dual guage pod
AEM failsafe flow gauge
AEM EGT gauge
AEM Oil Pressure gauge
BNA Solutions Tripe gauge a-pillar pod
Rear cargo net
Momo Cobra CF shift knob

[thenorm]

I think its SM (street mod). The engine and suspension mods almost fit into ASP (street prepared) but the CF wing is definate SM. its ok though, because the PAX values are almost identical.

however i would like to point out

AEM cold air intake
Invidia downpipe
Invidia Q300 exhaust

we have a very strict noise policy of 92dB. (and the event executive can park the car regardless of dB if the noise is deemed offensive to the neighbors)
If your car is much louder than a stock STI you may have issues complying.

[2010WRXLimited]

Thanks Norman. My exhaust is actually the quiet Invidia model, it has a resonator and full muffler so I will not offend any residents

[2010WRXLimited]

In the Street Mod class is it legit to remove my back seats? Thanks

[thenorm]

from the 2012 rules
"K. Rear passenger seat(s), including restraints and associated hardware
may be removed."

[PDM]

however you cannot remove side panels... - like in the trunk or hatch area. All "vertical" panels must remain. And back coverings ie: spare tire carpet/coverings and associated carpeting, plastic and undercoating must remain as supplied from factory